Yesterday around noon, the internet at my company started acting up. No matter, slowdowns happen and there’s roadwork going on outside: maybe they hit the fiber or something. So we waited.

Then our Samba servers started getting flaky. And the database too. Uh oh… That’s different.

We started investigating. Some machines were dropping ICMP packets like crazy, then recovered, then other machines started to become unpingable too. I fired up Wireshark and discovered an absolute flood of IGMP packets on all the trunks, mostly broadcast from Windows machine. It was so bad two Linux machines on the same switch couldn’t ping each other reliably if the switch was connected to the intranet.

So we suspected a DDOS attack initiated from within the intranet by an outside attacker. We cut off the internet, but the storm of packets kept on coming. Physically disconnecting machines from the intranet one by one didn’t do a thing either.

Eventually, we started disconnecting each trunk one by one from the main router until we disconnected one and all the activity lights immediately stopped on all the ports. We reconnected it and the crazy traffic resumed.

So we went to that trunk’s subrouter and did the same thing. When we found the cable that stopped all the traffic, we followed it and finally found one lonely $10 ethernet switch with… a cable with both ends plugged into the switch. We disconnected the cable and everything instantly returned to normal.

One measly cable brought the entire company to a standstill for hours! Because half of the software we have to use are cloud crap or need to call their particular motherships to activate their licenses, many people couldn’t work anymore for no good technical reason at all while we investigated the networking issue.

Anyway, I thought switches had protections against that sort of loopback connection, and routers prevented circular routes. But there’s theory and there’s reality. Crazy!

  • ramble81@lemm.ee
    link
    fedilink
    English
    arrow-up
    16
    ·
    6 months ago

    I really hope you meant “switch” when saying “hub”. I haven’t seen a hub used in decades. Also your switch should have some level of STP protection enabled to prevent that. Even if someone had a hub with a routing loop, STP would have disabled the ports.

    • dan@upvote.au
      link
      fedilink
      English
      arrow-up
      14
      ·
      6 months ago

      Basic unmanaged switches often don’t have any sort of protection, and on some fancier managed switches it’s disabled by default (no idea why)

      • Jajcus@sh.itjust.works
        link
        fedilink
        English
        arrow-up
        11
        ·
        edit-2
        5 months ago

        no idea why

        Because it makes initial connection much slower. Dumb switch - you insert a cable and it works. STP-enabled switch: you insert a cable and it takes a while until the port is enabled (unless you do extra configuration, appropriate for your network topology). This is annoying and for inexperienced users it could seem like the switch ‘does not work’. It is easier to sell a switch without such a feature enabled by default.