• CameronDev@programming.dev
      link
      fedilink
      English
      arrow-up
      2
      ·
      4 months ago

      I take my Chromecast on holiday, you basically have to factory reset it every time to change network. But my recollection is that you’ve always had to do that.

      • FrederikNJS@lemm.ee
        link
        fedilink
        English
        arrow-up
        2
        ·
        4 months ago

        That makes perfect sense, and switching is definitely annoying then… But the person I responded to said they had multiple WiFi networks at home… E.g. Not on holiday

    • jballs@sh.itjust.works
      link
      fedilink
      English
      arrow-up
      2
      ·
      4 months ago

      I personally have a Comcast router/modem with its own network. I have a network switch that I plug into the router that I use for hard coded stuff. Mostly my PC and a couple other things that I want to run fast instead of convenient. Then I have a WiFi mesh network that I run for most of my other devices, including my phone.

      So for my Chromecast, if I want to stream from my phone on the mesh network, I have it on one network. But if I want to stream from my PC, I have it on another network. While with most devices, changing the network you’re connected to is simple, it’s a massive pain in the ass with a Chromecast.

      • FrederikNJS@lemm.ee
        link
        fedilink
        English
        arrow-up
        1
        ·
        4 months ago

        So as far as I understand, you have

        • Outer router (Comcast), which has WiFi enabled
        • Inner router (your own), which has WiFi enabled, and further meshes with other WiFi mesh devices (or is the mesh separate?)
        • A plain switch, for stuff you want cabled and fast

        Is that correct?

        Why not get the WiFi in the Comcast router disabled, and use your inner network exclusively, such that both WiFi and ethernet devices are on the same network?

        That’s what I did with my network, and I even got the ISP to put their modem/router into bridge mode, so it’s completely transparent.

        • jballs@sh.itjust.works
          link
          fedilink
          English
          arrow-up
          1
          ·
          4 months ago

          I could, but I like having the router network as an option to connect to. I know the point of a mesh network is to improve WiFi connectivity overall, but every once in a while it will get a bit laggy when streaming a video. Probably because I’ve got like 90 some devices connected to it. I like having the option to switch my phone to the router network and go upstream of all the other stuff.

      • Natanael@slrpnk.net
        link
        fedilink
        English
        arrow-up
        1
        ·
        4 months ago

        What you need to do is put devices which you want to access from multiple networks in a specific network / VLAN and then bridge it over

    • foggenbooty@lemmy.world
      link
      fedilink
      English
      arrow-up
      0
      ·
      4 months ago

      I have a trusted network, an IoT network (where the CC would go), and a guest network.

      I know most people aren’t going to have the time or knowledge set up network segmentation, but it’s still good practice.

        • foggenbooty@lemmy.world
          link
          fedilink
          English
          arrow-up
          1
          ·
          4 months ago

          I mean, yes? I’m obviously using VLANs here. I’m not running a separate switch and AP for each network…