I’ve been having some serious issues getting PETG to print well, and I was wondering what settings other are using with success? I’m using a bedslinger in an enclosure and normally i print PLA with 200mm/s.

What are you doing for nozzle/bed temp, cooling fan, printing speeds etc? enclosed/open?

What is your printer capabilities normally for e.g. PLA?

  • ExcessShiv@lemmy.dbzer0.comOP
    link
    fedilink
    English
    arrow-up
    6
    ·
    19 days ago

    Yeah I’m having issues right now with material being super sticky and building up on the nozzle. after 30min of printing it has this blob of filament buildup on the nozzle which hits the print.

    I do actually print from a dryer, but it has been stored in a non-sealing box for a while without silica, so maybe it’s just too wet. I’m just not hearing the usual crackling of wet filament at all.

    • PlasticExistence@lemmy.world
      link
      fedilink
      English
      arrow-up
      3
      ·
      19 days ago

      Getting the first layer height correct is another key with PETG. You generally don’t want to have your Z offset further down than it takes to get an even layer. Find that level, then adjust the extrusion multiplier on your filament in order to fill in any minor gaps. Lowering your Z offset to fill in those gaps is going to contribute to buildup on your nozzle. As far away from the build plate as possible has been the right level for me.

      I can definitely print closer to the bed with other materials than I can with PETG.

    • j4k3@lemmy.worldM
      link
      fedilink
      English
      arrow-up
      2
      ·
      19 days ago

      Sometimes I get crackling sometimes not but it is still usually moisture. It takes a long time to drive out all the moisture from PETG IME

    • JeezNutz@lemmy.ml
      link
      fedilink
      English
      arrow-up
      1
      ·
      14 days ago

      What fixed this for me was raising the z offset (as in making the nozzle further away from the bed)