Fuck Trump and Musk, but seriously, this comic is just shit. Whatever you people call communism in the US has nothing to do with what actual communism was or is. The communism had its elites and whoever claims that people were or are equal under communism is just an ignorant. And, most importantly, communism in Soviet Union was just a brutal regime which silenced the opponents by killing or torturing them.

I see, to be honest I have not checked how clean it actually is. It is visually transparent, as opposed to the used one, but you are probably correct.

What I do is just expose the dirty isopropanol to sun or UV in general - the resin will precipitate. Then just filter it out and you have clean isopropanol.

Wow, so many bullshit points there it is hard to even start discussing them.

And this guy does not even touch the actual problems the wind turbines legitimately have.

Impressively ignorant.

Ja używam albo mapy.cz albo ViewRanger

It’s absolutely not. Median is a value in the middle of a sorted set and average is, well, average. In the set of 1, 7, 10: 7 is median and 6 is average.

That is only sort of true - this image is not made of electrons reflected by the nuclei. These are results from TEM imaging, so Transmission Electron Microscopy. The electron detector is placed behind the sample.

What you are describing is SEM - Scanning Electron Microscopy - in that case, the detector can be placed above the sample, for example (but not limited to) circularly around the beam to measure the backscattered electrons

In TEM the samples are cut into very thin slices (in the picture you posted it is said to be between 0.8nm - 30nm) and the crystal lattice acts as a diffraction grating for the electron beam. The diffraction pattern can be then used to reconstruct the crystal lattice structure.

Bridge from which the photo was taken used to be my daily commute. A lot can be said about Frankfurt, but Main is really nice around there.

They look like air bubbles to me, but it is weird they only come out after the bath. Could be they were already inside, but only covered by a thin wall of resin.

I usually use Isopropanol for bath not Ethanol, so I am not sure how your resin reacts with that. The bath should also be rather short, like 1min or something.

A few things to try:

• If you are shaking your resin before print, then give it like 10 minutes after you pour it into the vat, so all bubbles come out and pop
• lower the print speed
• add wait times between the end of lowering the plate and light on
• try to hollow out the model if possible, so there is less printing volume

Very interesting that they say it is peaking at 520nm, which is some shade of green.

Wonder if this might have played a role in plants being green. It is also surprisingly close to peak of sun spectrum. Maybe those two factors, combined with the existence of liquid water are favourable conditions for plants to develop the way they did.